Sherwood Scuba MAGNUM SRB5300 Specifications download pdf (Page 10)

4. Install a Sherwood regulator support handle (p/n TL113) into one of the low-pressure ports. Use

the support handle and a 15" adjustable wrench or bench vise to loosen the yoke nut from

the body . See Photo #1.

5. Remove the yoke and yoke nut from the body.

6. Use a 5/32" Allen wrench to remove all remaining port plugs from the body.

7. Use the Sherwood regulator support handle and a 15" adjustable wrench or a bench vise to

remove the cap from the main body. If the regulator is an Oasis or Blizzard model, the trim

ring will slide off at this time.

8. Remove the spring , any shims , and the piston assembly from the cap. Remove

both piston O-rings and discard them.

9. Remove the piston seat by pushing through the stem with the Sherwood piston seat

removal tool (p/n TL112) from the large end. The seat will then pop out. Discard the old seat.

10. Using a 3/32" Allen wrench, remove the flow control element assembly from inside the large

end of the main body. There are two styles of flow control assemblies. The old style with a

sintered stainless steel flow restrictor and the new style flow restrictor that is laser drilled P/N

5105-13 with a white filter P/N 5105-14. The new style complete assembly part number is

5105-15. If the regulator has the old style flow restrictor and it is functioning (13 to 27 cc/min) it

can be reused, however if it needs to be replaced use the new style. The black gasket can be

reused. The new style restrictor can be cleaned if it becomes plugged. Remove the white filter

and discard it. The white filter must be replaced P/N 5105-14. The laser drilled flow restrictor

can be cleaned in an ultrasonic cleaner and reused. The flow requirement for the new flow

control assembly is 20 to 30 cc/min.

NOTE

: If a Sherwood DIN adapter (p/n SAA5300)is installed in place of the normal yoke assembly, remove it

at this time. See Sherwood Scuba Technical Bulletin #104 for servicing procedures for the SAA5300 DIN adapter.

Photo #1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

No comments

Sherwood Scuba MAGNUM SRB5300 Specifications Page 10